Does Not include Engines

Looking for a classic Estes rocket kit with a modern twist? Look no further than the Tazz Estes rocket! This kit has been re-imagined with a specially designed engine mount featuring two molded tabs that keep the wing elevators in the flat position during boost for smooth flights, and then move them into the full "up" position at apogee for thrilling spins on the way down.

With balsa wings and alignment tabs that fit into pre-cut slots, aligning the wings is a breeze during assembly and after the glue dries, providing a strong wing-to-tube glue joint. Plus, the molded plastic retainers make installing and replacing the elevator actuator rubber bands a breeze.

You'll have a blast watching the Tazz Estes rocket spin wildly on its way down, with countless spins to count. Get ready for lots of fun flights with this classic Estes kit re-imagined!

Needed to Build (sold separately): Scissors, pencil, ruler, yellow glue, plastic cement, hobby knife, masking tape, primer (white), paint (black, white), and clear coat (optional).

What you Need for Launch:

• Estes Porta-Pad II Launch Pad
• and Electron Beam Launch Controller
• Estes model rocket engines
• starters and recovery wadding
• Four 1.5V high quality AA alkaline batteries (sold separately)

Recommended Engines: A8-3, B6-2, B6-4, C6-3